STM32F411CEU6 Development Board

STM32F411CEU6 Development Board

8,100.00

Out of stock

SKU: 0107 Categories: ,

Features
1. 25MHz High Speed Quartz Oscillator & 32.768kHz 6PF Low Speed Quartz Oscillator
2. Flash pads are reserved and offer USBDisk and FATFFS routine
3. Jumper cap can be used directly without installation. BOOT0 Internal 10K Resistor Pull Down
4. Factory has burned breathing lamp and USBCDC test process
5. Deploy the available MicroPython firmware and configuration file
6. Adjust the direction of the jump cap if it cannot be installed. Because the jump cap is wide on one side and narrow on the other.
7. V1.3 card with 3 buttons: reset button, BOOT0 button and user button.
Serial download of V1.3 and DFU download – Connect to PA9 and PA10 (connect to USB in DFU mode) by pressing the BOOT0 button and reset button, then release the reset button. After 0.5 seconds, release the BOOT0 button to start the serial download or DFU download. The corresponding software is flymcu or CubeProg

0

TOP

X